Diode Dynamics LED Resistor Kit, Set

Description

Description

Features:

• Prevents hyperblinking caused by installing LED bulbs
• Includes everything needed for installation
• 3-year warranty
• (4) resistors
• (8) quick-splice “scotch-lock” connectors

Prevent Hyper-blinking. When you replace incandescent turn signal bulbs with LEDs in most vehicles, the vehicle will start hyper-blinking. This is because the LED uses much less power, and the vehicle thinks the bulb is out. You can easily fix this problem by installing resistors.

Installation. Each resistor has 6″ leads for easier installation, and has a rating of 50 watts, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear), we recommend four total resistors.

To install, connect one side of the resistor to the positive turn signal wire, and the other side to negative (ground) with included connectors. To determine which wires to tap on a dual filament socket, we recommend using a voltmeter to test the two power wires. Simply engage your turn signal on the side you’re installing the resistor, touch your voltmeter probe to each pin inside of the socket, and the pin that gives a voltage readout is the power wire that needs to be tapped. Typically the ground wire is a black wire.

Note: This is a universal product and can be installed on any vehicle. It is recommend to use one resistor per turn signal bulb that is switched to LED. If you are installing both front and rear turn signal bulbs, it is recommend to use four total resistors.

Installation Instructions (opens in new tab): Click

Part Number: DD4025Q

Warranty Information

Warranty Information (opens in new tab): Click

Vehicles